Inox-Maxi

With the choice of hot water cylinders that can be supplied as direct or indirect, and with either single or twin coils, plus hot water buffer storage vessels, and all with capacities from 450 to 3000 litres; the designer of commercial hot water systems is well provided for with the Inox-Maxi Range.

 

Quality and reliability

Manufactured from Duplex Stainless Steel, the range of Inox-Maxi commercial cylinders and hot water buffer vessels are designed to last.

Low maintenance

Resistant to corrosion, there are no sacrificial anodes to check or change or powered active protection systems to monitor.

Unvented application

If required, all units can be provided with a matched unvented kit allowing for use with mains fed or boosted pressure water supplies.

IMPORTANT NOTE

The potable water expansion vessel supplied with an unvented kit has a nominal allowance for the capacity of the secondary hot water pipework of approximately 17.5% of the capacity of the hot water cylinder. If the volume of the secondary pipework is likely to exceed this figure then an appropriately sized additional expansion vessel must be installed also.

Solar compatible

The twin coil versions as well as the solar preheat cylinders are suitable/intended to be used with solar thermal installations to take advantage of free energy from the sun. With solar coil surface areas up to 10m², solar collector fields of up to 50m² can be accommodated.

Buffer vessels

Included in the family of Inox-Maxi cylinders are potable hot water buffer vessels that are intended for use in conjunction with plate heat exchangers or direct fired water heaters and with generous tapping sizes allowing for nominal peak flow rates of up to 3.2l/s.

Direct cylinders

For those applications where bulk hot water is required but there is no indirect heat source, such as remote location sports changing facilities etc, the Inox-Maxi direct cylinders are available with modular/multi immersion heaters with an input to the cylinder of up to 60kW.

Warranty

Manufactured from corrosion resistant stainless steel, the cylinder body carries a conditional 5 year warranty with all other components guaranteed for 1 year.

Special units

In the event that the extensive range of cylinders offered in this brochure does not meet the requirements for a particular project, we may be able to offer a bespoke unit tailored to specific needs; please contact MHS Boilers to discuss your project.